Stern Drive 100 Hour Service *Should be done every 2 to 3 years -Check battery and connections. -Check hoses, belts and clamps. -Check all electrical connections for corrosion and tightness. -Check ignition system. -Run motor to verify if any leaks and running condition. -Check gauges for proper operation. -Check operation of throttle control box. -Check engine with computer/tech for proper readings and codes. Adjust if needed. -Torque intake and exhaust manifolds. Clean spark arrester. -Change engine oil and filter(s). -Change fuel filter(s). -Top off power steering fluid if needed. -Top off power trim fluid if needed. -Grease all zerk fittings, steering and control cables. -Change stern drive gear oil. -Remove stern drive and check U-joints, gimble bearings and drive aligment. -Remove prop, grease shaft, and re-torque prop. -Check and record compression of cyclinders. -Check spark plug wires. -Replace water pump impeller, gaskets and o-rings. -Record engine hours. -Lube or oil trailer buddies. -Check trailer brake fluid, fill if needed Inboard 100 Hour Service *Should be done every 2 or 3 years -Check battery and connections. -Check hoses, belts, and clamps. -Check all electrical connections for corrosion and tightness. -Check ignition system. -Run motor to check for any leaks and running condition. -Check gauges for proper operation. -Check operation of throttle control box. -Check engine with computer/tech for proper readings and codes. Adjust if needed. -Check and record compression of cyclinders. -Torque intake and exhaust manifolds, clean spark arrestor (K&N to be done at yearly service). -Change engine oil and filter(s). -Change fuel filter(s). -Replace in tank fuel filter if equipped. -Replace impeller and gasket or o-ring. -Grease rudder port. -Re-torque prop nut. -Check hydraulic fluid if equipped. -Grease all zerk fittings, steering and control cables. -Change transmission fluid. -Check and adjust alignment. -Re-torque shaft coupler bolts. -Lube or oil trailer buddies. -Check trailer brake fluid, fill if needed. -Record all serial numbers. -Record engine hours. Please call for pricing *Prices vary for each service depending on the following: *Boat Model: (due to access of engine) *Boat's year: (due to additional parts that may be needed) *Engine Model